SERVICE MANUALBUNN-O-MATIC CORPORATION POST OFFICE BOX 3227SPRINGFIELD, ILLINOIS 62708-3227PHONE: (217) 529-6601 FAX: (217) 529-6644To ensure you h
10Electronic Controls (cont.)7. Reconnect the pink wire to terminal 5 of the elec-tronic control assembly.8. Loosen the compression fitting, remove t
11SERVICE (cont.)Electronic Controls (cont.)If voltage was present as described, the temperature control of the system is operating properly.If voltag
12This equipment is to be installed tocomply with the Basic Plumbing Code ofthe Building Officials and CodeAdministrators International, Inc. (BOCA)an
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYBunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) Airpots, thermal carafes, deca
3WARNING - Inspection, testing, and repair of electrical equipment should be performed only by qualified service personnel. Disconnect the dispenser fr
4TROUBLESHOOTINGA troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem r
5TROUBLESHOOTING (cont.)Problem Probable Cause Remedy Equipment will not operate (cont.)Automatic refill will not oper-ate after drawing hot water.Wa
6TROUBLESHOOTING (cont.)Problem Probable Cause Remedy Water boils continuously.Dispenser is making unusual noises.Ready indicator will not light.1.
7Faceplate Removal - H3/5 ELEMENT: After removing top cover, remove the two upper screws securing the faceplate. Carefully lift faceplate straight up
8SERVICEElectronic ControlsThis equipment is to be installed tocomply with the Basic Plumbing Code ofthe Building Officials and CodeAdministrators Int
9SERVICE (cont.)Electronic Controls (cont.)Liquid Level Control Test Procedure1. Disconnect the dispenser from the power source.2. Check the voltage
Kommentare zu diesen Handbüchern